Drying, cleaning and decontamination of HVAC systems and ductwork after water intrusion — to stop mold before it spreads through your building’s air.
When water gets into your HVAC system or ductwork — from a roof leak, burst pipe, flood or storm — you’re on a clock. Damp ducts, wet insulation and standing water in the system are an ideal mold incubator, and once mold takes hold inside the air system it spreads spores building-wide every time the HVAC runs. Fast, proper decontamination is what prevents a water event from becoming a mold problem.
Atlanta Air Experts handles water-damaged HVAC and ductwork: we assess moisture, remove unsalvageable wet materials, clean and decontaminate the system, and verify it’s dry — following recognized water-damage and mold-remediation principles — so your air system is safe, not a hidden source of mold.
We measure moisture in ducts, insulation and components to map what’s wet and what’s at risk.
Standing water is removed and unsalvageable wet duct insulation/liner is removed rather than ‘dried in place’.
Coils, pans and drains are cleaned and decontaminated to remove contamination and restore drainage.
Salvageable ductwork is cleaned and treated with an EPA-registered antimicrobial labeled for HVAC use.
We verify the system and materials are dry before closing up — the step that actually prevents mold.
Moisture readings, work performed and products used are documented for your insurer.
We inspect and measure moisture throughout the system and classify the contamination to scope the work correctly.
The affected HVAC is isolated under HEPA-filtered negative pressure so mold and debris can’t spread during work.
Standing water and unsalvageable wet insulation are removed; coils, pans, drains and salvageable ducts are cleaned.
Cleaned surfaces are treated with an EPA-registered antimicrobial labeled for HVAC use to control mold.
We confirm the system and materials are dry with moisture readings and document everything for your claim.
Wet ductwork grows mold — fast. Mold can establish in damp materials within a day or two. An HVAC system that stays wet doesn’t just hold mold; it distributes spores through every vent each time it runs. Prompt decontamination is what stops a leak from becoming a building-wide mold problem.
‘Dried in place’ isn’t clean. Wet fiberglass duct liner and insulation that got contaminated need to be removed, not just dried — recognized standards call for it. We remove what can’t be properly cleaned and decontaminate what can.
This ties into our mold remediation and commercial air duct cleaning services. Guidance: U.S. EPA on mold.
Related: post-fire HVAC cleaning · HVAC sanitizing · AHU cleaning · NADCA
Serving the greater Atlanta metro. Fast response, mold-focused, documented for insurance and coordinated with your restoration team.
Tell us about your facility — we will get right back to you.
